Then this is the  repair guide for you. This procedure shows how to take apart your sidekick 3 and clean the trackball and the trackball pad.  

Will this fix all of your issues? Probably, It work about 90% of the time.

If you need a new trackball, then click on the following link to see what is available.

T-mobile Sidekick Trackballs for Sale

Items Needed:

T6 Torx Screwdriver (or small flat tip screws that can be inserted into grooves of screw head.

A thin guitar pick (you can also use a small flat tip screwdriver or your fingernail if you prefer)

IPA (rubbing Alcohol) and some q –tips

Directions:

1. Power down unit.
2. Remove back cover and take out battery.
3. Flip you sidekick screen halfway to access the two screws that need to be removed. One has already been removed in this picture. Remove the screws using the T6 torx driver.
4. While still holding the screen in the half flipped position, gently lift the screen up and out.

   Warning

   Be careful not to touch the copper contacts or the connector. The pins on the connector of the base unit are very fragile. 

5. Set the Sidekick 3 LCD screen to the side.
6. Use a guitar pick, small flat tip screwdriver, or your fingernail, pop off the silver covers on the sides of the sidekick.
7. Remove the 2 screws near trackball. These screws need a T6 torx driver or a small flat tip screwdriver.
8. Remove the 2 screws near the d-pad. These screws also need a T6 torx driver or a small flat tip screwdriver.
9. Lift up top cover of Sidekick 3. Lift from the d-pad side.  This makes it easier to get the cover over the USB port.
10. Remove cover over the trackball.
11. Loosen the clips holding the sidekick 3 trackball in place. There is one on each side.
12. Lift the trackball up and off. Take a look and make sure the metal piece on the bottom is still there.  If you can not select with your trackball, that may be the problem.
13. Clean the trackball with IPA (or Rubbing Alchohol) and a q-tip. Make sure to rotate and clean it well.  Take a look and make sure that there is debris inside.  Do not take the trackball apart.  There are sensors in there that are hard to get back together if disassembled.
14. Clean the trackball pad on the main board.  It can get very gunked up.  See the picture below for proof of that. Use alcohol and a q-tip to clean this as well.
15. Install the trackball back on the pad.  The white tab should be toward the outer edge of the phone. Line up the trackball as shown below.  
16. Once the trackball is in place, snap it down until it locks into place.  This may take a few tries.  Don’t give up, it will snap back in.
17. Install the trackball cover back into place. (yes, I flipped the picture from step 10. Thanks for noticing)
18. Install the top cover back down on the sidekick 3.  Start by putting it over the usb porn and snapping down.
19. Install the 4 screws removed in steps 7 and 8.
20. Install the Silver side cover panels removed in step 6.
21. Rotate the LCD screen flip assembly to the half flipped position and install the two screws removed in step 3 and tighten them down.
22. Install the battery and battery cover back on the sidekick 3.
23. Power up you phone and enjoy your Sidekick 3 with its newly cleaned trackball by texting your friends about this site!

If you have questions please leave a comment below.

P.S.  I know some of these photos are from www.repairmysidekick.org. I also run that site so I gave myself permission.  I promise! =)

Disclaimer: Disassembling your Sidekick 3 will void the warranty. Proceed with the preceding instructions at you own risk. www.fixmysidekick.com is not liable for any damage that may occur. This website is in no way related to or associated with T-mobile or Danger Inc.

Originally posted 2008-10-28 21:39:29.

Related posts:

1. How to Replace a Sidekick 3 Screen Sidekick 3 Screen Replacement Replacing the LCD assembly flip screen...
2. How to Replace the Sidekick LX Faceplate and LCD Lens Is your Sidekick LX LCD lens frame cracked? Don’t like...
3. Replace the Sidekick LX Middle Frame Silver Chrome Trim Has the chrome around your Sidekick LX become scratched?  Is...

Fix My Sidekick

Related posts:

1. Clean or Replace Trackball on Blackberry Flip 8220 or 8230
2. Replace TrackBall on Blackberry 8830

BlackBerry Repair

Frustrated?

Think you need a new trackball for your Sidekick Slide?

Well, more than likely you don’t.  You just need to clean the sidekicks trackball.  This will take care of most of track ball issues.

Follow the procedure below and it enjoy a shiny, almost new like trackball today.

1: Take a deep breath and blow on the trackball area, rotate and do it again.  This may blow any particles that are blocking the sensors. If you spit a lot, make sure you have a handy wipe nearby!

2: This requires a Q-tip and some alcohol.  Turn off your sidekick, wet the end of the q-tip, and gently clean the trackball while rotating.  Use the dry tip of the q-tip to dry off and clean again with another alchohol dipped  swab. Let dry for a minute and try it out.  If this doesn’t work then try again.

Here is a video showing the cleaning technique.

Originally posted 2008-09-16 00:22:22.

Related posts:

1. How to Clean Trackball on Sidekick 3 Is the trackball on your Sidekick 3 not working?  Are...
2. How to Clean the Trackball on Sidekick ID Are you having a hard time rolling the trackball down...
3. How to Clean the Sidekick LX 2009 Trackball Are you having problems with your trackball on the Sidekick...

Fix My Sidekick

This requires a Q-tip and some alcohol.  Turn off your sidekick, wet the end of the q-tip, and gently clean the trackball while rotating.  Use the dry tip of the q-tip to dry off and clean again with another alcohol dipped  swab. Let dry for a minute and try it out.  If this doesn’t work then try again.

The following video will show you how to clean the trackball on your Sidekick 2009.

Hope that helps out with your Sidekick LX 2009 Trackball issues.

Let us know how it worked for you by leaving a comment below

Related posts:

1. How to Clean the Trackball on Sidekick ID Are you having a hard time rolling the trackball down...
2. How to Clean the Sidekick 2008 Trackball Is the trackball on your Sidekick 2008 not working?  Are...
3. How to Clean Trackball on Sidekick 3 Is the trackball on your Sidekick 3 not working?  Are...

Fix My Sidekick

Related posts:

1. Blackberry Flip 8220 LCD Screen Replacement
2. Replace TrackBall on Blackberry 8830
3. Clean the Trackball on a BlackBerry Pearl

BlackBerry Repair

Issues with the trackball on the Sidekick LX usually stem from a build of dirt and grime in the rollers.  This causes the sensors to get blocked and the trackball seems to stop working properly.

Thankfully, the trackball on the LX is really easy to clean.  The following solution will fix about 75 percent of your trackball issues.  It may take repeated cleanings but it will usually do the trick.

The sidekick trackball cleaning process requires Qtips and some IPA alcohol.

1.Turn off your sidekick

2. Moisten the end of the q-tip, and gently clean the trackball while rotating.

3. Clean again with another alcohol dipped  swab.

4. Use the dry tip of the q-tip to dry off.

5. Let dry for a minute and try it out.  If this doesn’t work then try again.

Below is a video that shows the trackball cleaning process on a Sidekick LX.

Let us know how it worked out for you by leaving a comment below.

photo credit: CharlieBoy808

Related posts:

1. How to Clean the Sidekick 2008 Trackball Is the trackball on your Sidekick 2008 not working?  Are...
2. How to Clean the Trackball on Sidekick ID Are you having a hard time rolling the trackball down...
3. How to Clean Trackball on Sidekick 3 Is the trackball on your Sidekick 3 not working?  Are...

Fix My Sidekick

Issues with the trackball on the Sidekick 2008 usually stem from a build of dirt and grime in the rollers.  This causes the sensors to get blocked and the trackball seems to stop working properly.

Thankfully, the trackball on the 2008 is really easy to clean.  The following solution will fix about 75 percent of your trackball issues.  It may take repeated cleanings but it will usually do the trick.

The sidekick trackball cleaning process requires Qtips and some IPA alcohol.

1.Turn off your sidekick

2. Moisten the end of the q-tip, and gently clean the trackball while rotating.

3. Clean again with another alcohol dipped  swab.

4. Use the dry tip of the q-tip to dry off.

5. Let dry for a minute and try it out.  If this doesn’t work then try again.

Below is a video that shows the trackball cleaning process on a Sidekick 2008

Let us know how it worked out for you by leaving a comment below.

Related posts:

1. How to Clean the Trackball on Sidekick ID Are you having a hard time rolling the trackball down...
2. How to Clean Trackball on Sidekick 3 Is the trackball on your Sidekick 3 not working?  Are...
3. How To Clean the Sidekick LX Trackball Is the trackball on your Sidekick LX not working?  Are...

Fix My Sidekick

Issues with the trackball on the Sidekick 2008 usually stem from a build of dirt and grime in the rollers.  This causes the sensors to get blocked and the trackball seems to stop working properly.

Thankfully, the trackball on the 2008 is really easy to clean.  The following solution will fix about 75 percent of your trackball issues.  It may take repeated cleanings but it will usually do the trick.

The sidekick trackball cleaning process requires Qtips and some IPA alcohol.

1.Turn off your sidekick

2. Moisten the end of the q-tip, and gently clean the trackball while rotating.

3. Clean again with another alcohol dipped  swab.

4. Use the dry tip of the q-tip to dry off.

5. Let dry for a minute and try it out.  If this doesn’t work then try again.

Below is a video that shows the trackball cleaning process on a Sidekick 2008

Let us know how it worked out for you by leaving a comment below.

Related posts:

1. How to Clean the Trackball on Sidekick ID Are you having a hard time rolling the trackball down...
2. How to Clean Trackball on Sidekick 3 Is the trackball on your Sidekick 3 not working?  Are...
3. How To Clean the Sidekick LX Trackball Is the trackball on your Sidekick LX not working?  Are...

Fix My Sidekick

Issues with the trackball on the Sidekick 3 usually stem from a build of dirt and grime in the rollers.  This causes the sensors to get blocked and the trackball seems to stop working properly.

Thankfully, the trackball on the SK3 is really easy to clean.  The following solution will fix about 75 percent of your trackball issues.  It may take repeated cleanings but it will usually do the trick.

The sidekick trackball cleaning process requires Qtips and some IPA alcohol.

1.Turn off your Sidekick or Hiptop 3

2. Moisten the end of the q-tip, and gently clean the trackball while rotating.

3. Clean again with another alcohol dipped  swab.

4. Use the dry tip of the q-tip to dry off.

5. Let dry for a minute and try it out.  If this doesn’t work then try again.

Below is a video that shows the trackball cleaning process on a Sidekick 3

Let us know how it worked out for you by leaving a comment below.

Related posts:

1. How to Clean the Trackball on Sidekick ID Are you having a hard time rolling the trackball down...
2. How to Clean the Sidekick 2008 Trackball Is the trackball on your Sidekick 2008 not working?  Are...
3. How to Clean the Sidekick LX 2009 Trackball Are you having problems with your trackball on the Sidekick...

Fix My Sidekick

Issues with the trackball on the Sidekick ID usually stem from a build of dirt and crud in the rollers.  This  can block the sensors  and causes the trackball seems to stop working properly.

Thankfully, the trackball on the Sidekick  is really easy to clean.  The following solution will fix about 75 percent of your trackball issues.  It may take repeated cleanings but it will usually do the trick.

The sidekick trackball cleaning process requires Qtips and some IPA alcohol.

1.Turn off your Sidekick ID.

2. Moisten the end of the q-tip, and gently clean the trackball while rotating.

3. Clean again with another alcohol dipped  swab.

4. Use the dry tip of the q-tip to dry off.

5. Let dry for a minute and try it out.  If this doesn’t work then try again.

Below is a video that shows the trackball cleaning process on a Sidekick ID.

Let us know how it worked out for you by leaving a comment below.

Related posts:

1. How to Clean the Sidekick 2008 Trackball Is the trackball on your Sidekick 2008 not working?  Are...
2. How to Clean Trackball on Sidekick 3 Is the trackball on your Sidekick 3 not working?  Are...
3. How to Clean the Sidekick LX 2009 Trackball Are you having problems with your trackball on the Sidekick...

Fix My Sidekick